For Task 1, I contributed to discussing the general idea for the floor plan of the building. Then, I also did the floor plan sketching with the members. Before sketching, I discussed with the members on the best software to use for floor sketching. After we are done with the sketching, I did some corrections to the sketching so it will fulfil the client's requirement according to the case study. For Task 2, we had to do a preliminary analysis. So, I contributed to coming up with three questions and the answer for each question. Following Task 2 is Task 3 where we had to do the project setup. My contribution to Task 3 was discussing the list of devices. I also made sure that the devices we chose are aligned with the requirement and budget provided. For Task 4 we had to determine the cable and connection. In this task, I helped in identifying the number of connections, switch ports, and patch cords for the labs. In Task 5, we had to come up with an IP address. So, using the network address given, I came up with the IP address for the switch, access point, and PCs in general-purpose lab 2. Task 6 is where we are required to compile the whole project in a single report. In this task, I contributed to coming up with the abstract and introduction of the report.
My group members are Ayesha Imelda, Wan Norazira, and Carmen Tey Ye Yao. For Task 1, the three of them contributed to coming up with the floor plan of the building and the software needed for sketching. Then, Azira helped me in doing the corrections so that the floor plan fulfils the client’s requirements. Ayesha and Carmen finalised the report for this task. For Task 2, Carmen and Azira came up with questions and answers while Ayesha did the feasibility answer and reasoning. In Task 3, they all came up with a list of devices needed. Ayesha and Carmen helped in aligning them according to the requirement and budget while Azira helped in completing the report and summarising the major differences. Following that, in Task 4, Ayesha and Azira determined the number of connections, switch ports, and patch cords for the IoT lab, and video conferencing room respectively. Carmen contributed to determining the types and lengths of cables for all labs and rooms. For Task 5, they all helped in coming up with IP addresses for the switch, access points, and PCs in labs and rooms. Lastly, in Task 6, Ayesha did the reflections for Task 4 and Task 5. Then, she came up with a conclusion and listed down the members’ responsibilities. Azira contributed to doing the project background while Carmen did the reflections for Task 1, Task 2, and Task 3. Then, she also combined the reports of Task 1 until Task 5.