Monday : 06/08/2018
Continue on the task of the making the procedure document needed for the installation of S200 Skynode traking system on Helistar's Airbus Helicopter EC 120.
While doing that, Kak addah has give me a task on completing the procedure document on the Removal and Installation of Owner's Plate on the Helistar's Airbus Helicopter AS 350 B2 by replacing the previous Owner's Plate.
After completing the modification document on the installation of Owner's Plate last week, today task is to completing the ICA of the installation of owner's plate for Helistar's Airbus Helicopter AS 350 B2.
ICA is a instruction for continued airworthiness. It contains the instruction of installation. Section A describe about the maintenance procedure , Section B describe the inspection and maintenance check and lastly Section C contain Airworthiness limitation.
Tuesday : 07/08/2018
Assisting hafiz on making drawing for installation of skynode s200 system on EC120 Airbus Helicopter.
Drawing that have been done is the drawing of the plate rod supporting RC600/A in the front panel in the cockpit. The dimension is around 8 cm long and 16 cm width.
We also drawn the full panel in the cockpit to show actual dimension on where it installed and placed for the RC6000/A
Thursday : 09/08/2018
Today i continue on completing the Structural Justification Report for the installation of Owner's Plate on Helistar's Airbus Helicopter AS350B2.
The ER contains some parts that need to be completed. The intoduction, Objective, the Description about the equipment needed, mechanical properties and design data, Fabricated parts that are agreed on and the most important part is the Load case.
Another section also includes the Analysis and Discussion that comply with the demand from the regulation of the state air law. For the Owner's Plate is ususallyhave to make compliance with JAR 301, JAR 305, JAR 307, JAR 561, JAR 601(a) , 601(b) and lastly JAR 613(a). All of the above regulation is must be justify according to the demands.
Wednesday : 08/08/2018
Asisting hafiz on making a drawing for fabricated part on the mounting that supported the Skynode on the cargo part of the helicopter.
The dimension for mounting sheet metal is about 270 cm long and 150 cm width. It a bit longer and wider than the actual size of the Skynode is mount on top of the mounting sheet metal. Based on the calculation is it safe to mount it and have four screw that correct to the skynode
Friday : 10/08/2018
Continue on completing the ICA for Skynode installation of Skynode S200 on EC120 Airbus Helicopter. Proceed on completing the document by filling the installation Procedure for Skynode S200, Antenna and RC6000.